1.僅當導軌式升降平臺的負載無法開始工作時，才應檢查液壓系統的壓力。如果壓力低于正常范圍，則可以調節溢流閥的容量。

1. Check the pressure of the hydraulic system only when the load of the rail type lifting platform cannot start working. If the pressure is below the normal range, the capacity of the relief valve can be adjusted.

2.液壓油變質或有雜質。長期使用導軌提升器的工作油后，工作油中可能會有雜質或變質。將進行采樣以檢查其是否包含固體顆粒，變色或氣味。液壓油。

2. The hydraulic oil is deteriorated or has impurities. After long-term use of the working oil of the guide rail lifter, there may be impurities or deterioration in the working oil. A sample will be taken to check whether it contains solid particles, discoloration, or odor. Hydraulic oil.

3.導軌式升降平臺的液壓管路也是非常緊密的一環。檢查液壓管路是否暢通。升降機提醒大家檢查每個液壓閥是否覆蓋了單向截止閥，電磁換向閥，比例控制閥和溢流閥，以防止堵塞。如有問題，應盡快清洗或更換液壓閥。

The hydraulic pipeline of the rail type lifting platform is also a very tight link. Check whether the hydraulic pipeline is smooth. The elevator reminds everyone to check whether each hydraulic valve is covered with a one-way stop valve, electromagnetic directional valve, proportional control valve, and overflow valve to prevent clogging. If there is a problem, clean or replace the hydraulic valve as soon as possible.

4.檢查導軌式升降機的液壓系統是否泄漏。著重檢查液壓管和接頭，缸體和液壓閥的接頭。如果發現液壓油泄漏，則更容易混入墊片或攪拌原料皮帶。

4. Check the hydraulic system of the guide rail elevator for leaks. Focus on checking the hydraulic pipes and joints, as well as the joints of the cylinder block and the hydraulic valve. If a hydraulic oil leak is found, it is easier to mix the gasket or stir the raw material belt.

5.導軌式升降平臺液壓泵也是影響液壓油流量的關鍵因素。如果長時間使用液壓泵，很容易出現問題。當液壓升降平臺的速度減慢時，應檢查液壓泵的供油流量是否穩定。如果發現問題，請盡快與廠家聯系以避免保修期。

5. The hydraulic pump of the rail type lifting platform is also a key factor affecting the hydraulic oil flow. If the hydraulic pump is used for a long time, problems can easily occur. When the speed of the hydraulic lifting platform slows down, check whether the oil supply flow of the hydraulic pump is stable. If any problems are found, please contact the manufacturer as soon as possible to avoid the warranty period.

6.不能自行調試溢流閥，主要原因是導軌式升降平臺運行緩慢的主要原因是后期人為造成的。因此，重要的是在正常使用時維護和維護演播室，以減少事故的發生提高工作效率。

6. The main reason why the overflow valve cannot be adjusted by oneself is that the slow operation of the guide rail type lifting platform is mainly caused by human factors in the later stage. Therefore, it is important to maintain and maintain the studio during normal use to reduce accidents and improve work efficiency.

感謝您的閱讀，此文的文章來源：升降貨梯廠家更多的內容和問題請點擊：http://m.shyulang.cn我們會繼續努力的為您提供服務，感謝您的支持！

Thank you for reading. The source of this article is: Elevator manufacturers. For more information and questions, please click: http://m.shyulang.cn We will continue to work hard to provide you with services, thank you for your support!